CS COOKTOP SERIESInstallation GuideMODELS:CS-366CS-364GLCS-364GCS-484GGCS-486GLCS-486GDCS-485GD
STEP 3: (CONTINUED)6) Cut the openings for the following installation: Standard counter top installation, see Fig. 5A Deep counter or island install
CABINET PREPARATION108 7/16"22-3/4"26 1/2"23-1/4"3" To Center Line of Gas Inlet1/2"1/2"5/8"Cabinet face for in
STEP 4:BACKGUARD KITS:The backguard is located as shown in Fig. 6. Secure the backguard to the wallbehind the cooktop.Specific instructions for insta
12ELECTRICAL / GAS CONNECTIONSSTEP 5:ELECTRICAL CONNECTIONS Power requirements Cooktop: 120 VAC, 60 Hz., single phase 7 Amp. CS-48: 15 Amp. Max. CS
HOOK-UP TO GAS SUPPLY13STEP 6:HOOK-UPA manual valve must be installed external tothe appliance, in an accessible location fromthe front for the purpos
TEST AND ADJUSTMENTS14STEP 7:CAUTION:For warranty coverage, DCS requires that burner adjustments be made by aqualified technician at the time of insta
INSTALLER FINAL CHECKLIST15GENERAL Placement of unit. Specified clearance maintained to cabinet surfaces. Unit Level - front to back, side to side.
CS 36” / 48” WIRING DIAGRAM16
1Thank you for selecting this DCS CS Cooktop.Because of this appliance’s unique features we have developedthis Installation Guide. It contains valuabl
TABLE OF CONTENTS2INTRODUCTION...
INTRODUCTION3The DCS Professional CS Cooktops feature a large number of features varying with each model . Allmodels feature a minimum of 4 surface bu
MODELS4
PLANNING THE INSTALLATION5RECOMMENDED INSTALLATION INSTRUCTION(If installing a full backguard with the cooktop)A) Vent HoodB) Backguard SystemC) Cookt
UNPACKING AND HANDLING6STEP 1:MOVING AND PLACING THE COOKTOPNOTE: If a solid side cabinet wall exists on one or both sides, you will need to notch the
VENTILATION REQUIREMENTS7STEP 2:A suitable exhaust hood must be installed above the cooktop. The following chart indicates theminimum blower capacity
CABINET PREPARATION8GHFDEMin. 48" Wide HoodMin. 36" Wide HoodI16" Electrical and Gas Supply.2"13"Max.12" Min. toCombust
Kommentare zu diesen Handbüchern