DCS C-24W Installationshandbuch

Retain this manual for future reference.CERTIFIEDDESIGNAMERICANASSOCIATIONGSA®PROFESSIONALDCS-C-24WWOK COOKTOP MODELCARE & INSTALLATION MANUAL

HEADERTo Adjust:1) Light burner.2) Turn knob to lowest setting (all the way counterclockwise).3) Remove knob.4) Hold the valve shaft still. Ins

HEADERA Special Message to our Customers,We are glad you selected one or more of these DCSProfessional Appliances. By following a few simple proce-du

HEADERYour new DCS Professional appliances have been designedto be safe, reliable appliances. However, use extreme carewhen using these restaurant ca

HEADERDo not use aluminum foil as a shield against food spills ordrippings around any of these appliances. This could ob-struct the flow of combustio

13HEADERBefore using wok remove all packaging and labels beforeuse or seasoning the wok.1. Be sure the drip trays are in place beforeuse.2. When first

HEADERA VENTILATING HOOD OF ADEQUATE CFMCAPACITY VENTED TO THE OUTSIDE OF THEHOUSE MUST BE INSTALLED ABOVE THIS WOK.FOR MOST KITCHENS WITH A WALL MOUN

HEADERBe careful when cleaning surface of wokwhile appliance is still hot.All parts of the wok can be cleaned with hot soapy water,rinsed and dr

HEADER16WARRANTYThis warranty applies to appliances used in residential applica-tions; it does not cover their use in commercial situations.This warra

As product improvement is an ongoingprocess at DCS, we reserve the right tochange specifications or design withoutnotice.Litho in USA 8-97Part No. 1

TABLE OF CONTENTSSTEP 1: Safety Precautions ...2STEP 2: Cabinet Preparation Cooktop Installation ...

HEADERWARNING:Disconnect power before installing Before turn-ing power on, be sure that all controls are in the“off” position.Read entire instructions

1. To ensure professional results, the cabinet and countertop openings should be prepared by a qualified cabinet worker.2. The clearances shown in F

5. Establish the centerline of the cooktops desired location. It should be the same as the center or the overhead ventilation hood.6. Cut the opening

PLACING & ANCHORING - ELECTRICAL Lift and place the cooktop in the opening. Be careful not topinch the power cord or gas inlet between anythi

If installation of a properly grounded wall receptacle isimpossible at the time of installation, consult your local electri-cal inspector for permissi

GAS REQUIREMENTSVerify the type of gas supplied to the location. The cook-top is shipped from the factory set up and adjusted for nat-ural gas. The

HEADERThe backguard must be installed when there is less than a12” clearance between combustibles and back edge ofcooktop. For island installations a