DCS HD30 Bedienungsanleitung PDF herunterladen (Seite 27)

INSTALLATION INSTRUCTIONS

Complete the installation



Place the top trim onto the downdraft unit.



Push the power button on the top trim, the downdraft unit will rise. (The blower will

begin to vent immediately if the blower control slider is set to an ‘On’ position).



Remove the labels, screw and brackets as shown in Fig.29. These brackets are used to

hold the grease filter microswitches in place during transportation. They are located at

the top of the downdraft unit in the centre behind each grease filter.



Connect the top trim to the downdraft unit by threading the ⁄” (7mm) nuts onto

the top trim screws Fig.30.



Install the grease filters Fig.31.



Check the blower operation. If the blower does not work refer to the ‘Troubleshooting’

section on page 28.

Attach the ducting



For the internal blower box, use 6” (152mm) round ducting and the 6” (152mm)

diameter back draft damper.



For the remote blower, use 10” (254mm) round ducting.



Attach ducting using clamps or aluminum duct tape to seal all joints and vent outside.

Remove packaging



Remove all packaging and protective wrappings.

Install the cooktop



Install the cooktop according to the manufacturer’s instructions.



Check to make sure that the rear edge of the cooktop overlaps the front edge of the

downdraft unit by ⁄” (8mm) Fig.32.

Fig.29

Fig.30

Fig.31

The internal or remote blower

can alternatively be mounted

on the back of the appliance

⁄” (8mm)

Fig.32

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare

DCS HD30 Bedienungsanleitung Seite 27

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein DCS HD30