DCS UR624 Bedienungsanleitung PDF herunterladen (Seite 3)

INTERIOR LIGHT . . .

(Optional Feature)

When supplied with an interior light, your refrig-

erator uses a 15 watt appliance light bulb. To replace

the light bulb, proceed as follows:

1. Unplug the power cord from the wall receptacle.

2. Open the cabinet door.

3. Remove the 3 screws on the front face of the light

lens using a Phillips screwdriver.

4. Remove the lens.

5. Unscrew the existing bulb and replace with an

equivalent 15 watt, threaded, intermediate base ap-

pliance bulb. Do not replace with a bulb higher than

15 watts.

6. Reassemble.

To clean the light assembly, disconnect the power cord and wipe the assembly with a mildly damp cloth.

Dry the unit completely before connecting the power cord. Make sure you disconnect the refrigerator’s power cord

plug from the electrical receptacle BEFORE you clean the light assembly.

THINGS TO REMEMBER . . .

1. Allow 24 hours for your refrigerator to reach a new temperature setting.

2. The motor will start and stop often. It must do this to maintain the temperature you select.

3. Keep your refrigerator reasonably level.

4. Unplug the refrigerator before working on anything with the electrical system.

Exercise caution when sweeping, vacuuming, or mopping near the front of the unit. Damage to the grille and/or

the light fixture switch can occur.

6. For all cleaning of the refrigerator, mix 2 tablespoons baking soda with 1 quart warm water or use mild soap. Do not

use strong cleaners or scouring powder or pads.

7. Keep your refrigerator out of direct sunlight.

8. Do not splash or spray water on or under the refrigerator.

9. Clean your refrigerator’s condenser periodically to maintain proper cooling performance.

- 3 -

NOTE:

The rocker switch located on the right side of grille

controls the interior light and overrides the door plunger

switch allowing the light to stay on even with the door

closed. To have the interior light go out after the door

is shut, make sure the rocker switch is pushed in to

the “off” position.

(Optional Feature)

1 2 3 4 5 6 7 8

Keine Kommentare

DCS UR624 Bedienungsanleitung Seite 3