DCS C-24 Spezifikationen PDF herunterladen (Seite 7)

Chapter 3: Rack Mounting the Switch

7000 Series 1 RU – Gen 2 Quick Start Guide PDOC-00019-13 7

Chapter 3 Rack Mounting the Switch

Important! The rack mounting procedure is identical for all switches covered by this guide. Illustrations in this

chapter depict the mounting of a DCS-7124SX switch.

The accessory kit provides components for installing the switch in two-post and four-post racks.

• Section 3.1 provides instructions for mounting the switch in a two-post rack.

• Section 3.2 provides instructions for mounting the switch in a four-post rack.

Both options require the attachment of mounting brackets to the switch chassis. Each chassis side

contains six pairs of holes that align with bracket holes. Bracket hole orientation is symmetric, allowing

bracket placements where the flange is flush with the front or rear switch panel (Figure 2).

Bracket holes are horizontally equidistant, allowing bracket placements where the flange is not flush

with either panel (Figure 3). This placement supports a center-rack mount.

After completing the instructions for your rack type, proceed to Chapter 4: Cabling the Switch.

3.1 Two-Post Rack Mount

To mount the switch onto a two-post rack, assemble the mounting brackets to the chassis, then attach

the brackets to the rack posts. The accessory kit includes the following two-post mounting parts:

• 2 mounting brackets

• 12 M4x5 flat head Phillips screws

Figure 2: Chassis and Mounting Bracket Alignment for Front and Rear Rack Mounts

Figure 3: Chassis and Mounting Bracket Alignment for Center Rack Mount

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Keine Kommentare

DCS C-24 Spezifikationen Seite 7